Watermark Type: Logo

This page describes how to configure the Logo watermark type within a rule. The Logo watermark allows you to overlay your brand logo on product images with flexible positioning and display options.

Logo Configuration Options

Upload Logo

Upload the logo image that will be used as the watermark. For best results, use a high-quality image with a transparent background.

Position

Choose the base position of the logo on the image:

• Top left
• Top right
• Bottom left
• Bottom right

This position works together with margin settings to fine-tune placement.

Placement Area

Define where the logo can be placed:

• Within fill area: The logo is placed within the visible content area after image scaling or cropping
• Within image area: The logo is placed based on the original image boundaries

Placement Layer

Control how the logo is layered relative to the product image:

• In foreground: The logo appears on top of the product image
• In background: The logo appears behind the product image

Scale

Adjust the size of the uploaded logo.

The scale range is from 10% to 130%, allowing both smaller and larger logo displays depending on your design needs.

Visibility

Control the opacity of the logo.

The visibility range is from 3% to 100%, where lower values make the logo more transparent and higher values make it more visible.

Margin X

Set the horizontal distance between the logo and the left or right edge of the image.

The value is measured in pixels (px).

Margin Y

Set the vertical distance between the logo and the top or bottom edge of the image.

The value is measured in pixels (px).

Rotation

Rotate the logo to a specific angle.

The rotation range is from 0 to 180 degrees.

Tile

Enable repeated display of the logo across the image.

Available options include:

• No
• Horizontal
• Vertical
• Both horizontal & vertical

Tiling is useful for stronger protection against image theft.

Tile Padding X

Set the horizontal spacing between repeated logos when tiling is enabled.

The value is measured in pixels (px).

Tile Padding Y

Set the vertical spacing between repeated logos when tiling is enabled.

The value is measured in pixels (px).

Apply To

Choose which images within a product the logo watermark should be applied to:

• All images
• First photo only
• Skip first photo
• Second photo only

This option gives you control over watermark visibility across a product’s image gallery.

Updated on: 04/06/2026